Level 1 sweep and inspection to the NFPA 211 annual standard - flue, crown, cap, and flashing checked and photographed
Chimney sweep logs do not sweep chimneys. They loosen some creosote - which then falls where a brush and vacuum still have to collect it.
Olympia Chimney Chimney Cap & Crown in Jamaica: What to Know First
We install, replace, and repair Olympia Chimney caps and crowns in Jamaica, NY, with most jobs completed in a single visit. A replacement Olympia Chimney cap for a standard single-flue setup typically runs $240 to $390 installed; crown repair or recoating lands between $350 and $700 depending on surface area and condition. Every estimate is written before any work starts, so there’s no surprise line item after the fact.
If you own a home in Jamaica with an Olympia Chimney flue cap or masonry crown that’s seen better decades, this page tells you what actually fails, what it costs to fix, and how we document the work. Call (516) 240-9612 for a free written estimate, or keep reading to understand what you’re dealing with.
How Olympia Chimney Products Fail - and How We Fix Them
- Olympia Stainless Steel Caps - mesh crimp loosening at the base ring. On Olympia’s standard stainless caps, the factory crimp where the mesh meets the base ring is the first thing to work loose after a few hard winters near Jamaica Bay. Rain gets under the mesh, corrosion starts at the crimp points, and the cap begins to rattle in high wind. We drill out the old rivets and re-secure with stainless hardware before re-bedding the base. When the mesh is too far gone, we replace the cap assembly, and that decision is made only after you see a photo of the damage.
- Olympia Galvanized Multi-Flue Caps - edge seam split at the corners. Olympia’s larger multi-flue caps use a folded corner seam that’s precise off the shelf but vulnerable to thermal cycling. In Jamaica’s rowhouses where one chimney serves multiple flues and the boiler fires unevenly, that seam splits and water channels straight down into the crown. We rebuild the seam with a sealed corner gusset or recommend a custom cap sized to your crown’s actual dimensions rather than a stock width that overhangs too much.
- Crown spalling where the cap’s mounting screws penetrate the masonry. This is a Jamaica-specific pattern we see on older homes along Jamaica Avenue and the surrounding streets. Olympia caps hold tight, but when they’re screwed directly into a crown that’s already soft from decades of freeze-thaw, the anchor points crumble and the cap lifts on one side. The fix isn’t just a new cap - we repoint the anchor bed, install a proper cementitious crown coat around the mount points, and then set the cap. Skip the crown repair and you’ll be back on the roof in two years.
- Olympia Draft King caps - bird screen clogging faster on inner-block chimneys. The Draft King line has a fine mesh that does its job for birds and debris, but on Jamaica blocks with mature London plane and maple canopies, the mesh loads up with seed wings and cottonwood fluff two or three times faster than the manufacturer’s cleaning interval suggests. A clogged cap draft starves the fire and pushes smoke back into the living room. We’ll show you the camera footage of the blockage, then clean and inspect the cap instead of selling a replacement you may not need.
- Improper aftermarket sizing - a cheap universal cap wears out an Olympia crown faster. We regularly see Olympia crowns deteriorating under caps that were never the right footprint. A universal cap that overhangs by an inch or two directs runoff onto the crown’s edge instead of into the drip groove, and that edge erosion is exactly what starts spalling. When we replace a cap, we measure the flue opening and crown dimensions separately, and if the crown’s drip edge is worn, we address it in the same visit.
Our Olympia Chimney Chimney Cap & Crown Process

- 1
You call, we answer. A live person at (516) 240-9612 takes your information, we schedule a visit, and you get a text when our technician is on the way. No voicemail tag, no web form purgatory.
- 2
Camera inspection first. We run a camera down the flue and across the crown before touching anything. NFPA 211 Level 2, every visit, no exceptions.
- 3
You see what we see. The camera feed comes to your phone or tablet in real time. We point out the cap condition, the crown surface, the flue tile, and anything else the scope finds. Corrine Halstead built this practice around one principle: the camera doesn’t negotiate - it just shows what’s there.
- 4
Written price before work. We give you a written scope, written price, and written warranty on the spot. If an Olympia OEM part is the right call, we quote it. If a quality aftermarket cap from our own supplier network fits better and costs less, we tell you that too, with the reasons.
- 5
The repair happens same visit. Cap replacement, crown coating, repointing, re-bedding - we carry the common parts and materials on the truck. On our shelves you’ll find Olympia, DuraFlex, HeatShield, and Gelco components, so we’re never forcing one brand where another fits better.
- 6
Documented record when we’re done. You get a photo file of the before, during, and after. Clause 4 of the Haven Standard has required this on every job since 2009, and it’s never been optional. That record is your proof the work was done, and it’s what makes the 365-Day Done Right Promise something we can actually stand behind.
Before
AfterWhat Olympia Chimney Chimney Cap & Crown Costs in Jamaica
Here’s what you can expect to pay in Jamaica for common Olympia Chimney cap and crown work, parts and labor included:
- Olympia single-flue stainless cap replacement: $240-$320
- Olympia multi-flue cap replacement, standard sizing: $340-$520
- Crown crack repair and recoating: $350-$550
- Full crown rebuild (bad spalling or missing sections): $650-$900
- Cap cleaning, mesh clearing, and inspection: $95-$150
What moves the price: roof pitch and access difficulty (three-story walkups in Jamaica cost more than a one-story rear extension), crown surface area, multi-flue vs. single-flue, and whether the existing cap needs anchoring hardware replaced. We don’t pad quotes with vague “materials fees.” The number on the written quote is the number you pay, and if a competitor’s written estimate comes in lower, bring it to us for a free second opinion. For an exact quote on your chimney, call (516) 240-9612.
Why Jamaica Homeowners Call Level Two Chimney Jamaica for Olympia Chimney Work

We’ve inspected and cleaned more than 38,000 chimneys since 2009, and a fair share of them sit within a mile of Jamaica Center. That matters because Jamaica’s housing stock has specific quirks: older row houses with shared party-wall chimneys, flat-roof walkups where the crown is the only drainage plane, and boiler vents that run year-round and keep the masonry in constant thermal movement. Our techs know what an Olympia cap looks like after a decade on a Jamaica roof, because they’ve taken it off and shown it to the homeowner.
We’re not a manufacturer-authorized Olympia Chimney dealer, and we don’t pretend to be. We’re an independent Olympia Chimney service provider, which means we recommend the part that’s right for the chimney, whether that’s OEM or a quality aftermarket option from DuraFlex, HeatShield, or Gelco. Every technician is background-checked and uniformed, every job carries the 365-Day Done Right Promise, and every visit ends with a photo record you keep. Our license number is on this page. Our price is on this page. Our warranty is written, not spoken.
FAQs
An Olympia single-flue stainless cap replacement in Jamaica costs between $240 and $320 installed, while multi-flue caps run $340 to $520 depending on width and roof access. These prices include removal of the old cap, labor, and written warranty. Call (516) 240-9612 for a free written estimate on your specific chimney.
We repair Olympia caps whenever the mesh, base ring, or seam is still structurally sound, which usually means re-riveting loose corners and re-bedding the base. If the mesh is corroded through or the corner seams are split beyond a clean rebuild, a replacement cap is the cheaper long-term fix. You’ll see the camera evidence either way before you agree to anything.
Yes, we stock and source Olympia Chimney OEM caps and components for Jamaica clients, but we’re independent, not manufacturer-affiliated, so we’ll also recommend a quality aftermarket part from DuraFlex, HeatShield, or Gelco when it performs as well for less. The written quote you receive will name the exact part and manufacturer before any work starts, per Haven Standard Clause 1.
Most single-flue cap replacements and crown recoats in Jamaica are done in two to four hours, including the camera inspection and the photo record. Full crown rebuilds with significant spalling typically run longer, and we’ll tell you the timeline in writing before we schedule.
A cracked or spalling crown lets water into the flue and the masonry behind it, which in this climate accelerates freeze-thaw damage and eventually threatens the flue liner’s integrity. We’ve pulled caps off Jamaica roofs where a small crown crack had become a full-thickness erosion in under three years. The good news: crown coating is one of the least expensive chimney repairs per year of life it buys. Call (516) 240-9612 and we’ll show you exactly what’s happening up there.
Yes. Every Olympia Chimney cap and crown job we perform in Jamaica is covered by the 365-Day Done Right Promise: if it’s not done right, we make it right. You also receive the manufacturer’s warranty on any cap component we install, and both are documented in the written warranty you get before work begins. Nothing verbal, nothing implied.
If you need an Olympia Chimney cap or crown looked at in Jamaica, call (516) 240-9612 and we’ll get you a written estimate. The camera doesn’t negotiate - it just shows what’s there.
Written by Corrine Halstead, Owner, Level Two Chimney Jamaica at Level Two Chimney Jamaica, serving Jamaica and nearby areas.





Before
After
Before
After
Before
After